Maple Syrup Jar Delrin Leather Stamp
Create crisp impressions on veg-tan leather with this stamp. Made from durable Delrin, its flat profile is designed for press use and creates clean, even impressions through repeated use.
- Made from ¼" white Delrin (acetal)
- Listed size reflects the stamped image area
- Product images show the orientation of the stamped mark
- Edge-to-edge stamp design with a minimal border (under 0.5mm)
- Tested for a clean impression before shipping
Use on veg-tan leather only
Press only (no hammer or mallet)
Each stamp tested before shipping
LEAD TIME + SHIPPING
LEAD TIME + SHIPPING
Each stamp is made to order and ships fast—within 2–5 business days.
CUSTOM OPTIONS
CUSTOM OPTIONS
Need a different size or a custom design? We’ll help create the right stamp for your project. Start a Custom Stamp
CARE INSTRUCTIONS
CARE INSTRUCTIONS
For crisp impressions every time, start with a clean stamp. Brush away debris with a soft toothbrush. For a deeper clean, use mild soapy water or isopropyl alcohol as needed, then dry completely before storing.
How to Get a Clean Impression
Stamping on veg-tan leather is simple with a few basic supplies. Follow the steps below, practice on a scrap piece first, and you’ll be ready to stamp with confidence.
Wet the Leather
Evenly moisten the leather and allow the surface to begin drying.
Add Stamp + Press Plate
Place the stamp and top plate over your leather, aligned beneath the ram.
Press Leather
Apply firm, even pressure for a few seconds to create the impression.
What Makers Are Saying
"This stamp has gone through hell and back. It’s gone through hundreds of uses in a press and is still going strong."
"A huge thank you to @allgoodeatherco for making beautiful, high-quality leather stamps."
"I am completely blown away that you could get al the detail into such a small stamp! 1" stamp and the text is so crisp. Thank you for such amazing and quick service."
Tips + Tricks
Keep your leather flat
Keep your leather flat
Keep your leather completely flat while pressing. Any lifting or bending can cause corners or edges to appear in the impression.
Use even pressure
Use even pressure
You don’t need excessive force to create a strong impression. Apply steady, even pressure for about 5 seconds. If you’re using a heavy-duty press (5-ton or higher), avoid over-pressing.
Pressing larger stamps
Pressing larger stamps
For stamps larger than a few square inches, press in sections for the best results. Start in the center, then carefully move the stamp and leather to press each area until the full design has been stamped.
Practice first
Practice first
Before stamping your finished project, practice on scrap veg-tan leather. Most makers find it takes a few impressions to get comfortable. If you notice white Delrin residue on your first few impressions, it can be gently brushed away once the leather has fully dried.
No arbor press? Use a C-Clamp
No arbor press? Use a C-Clamp
A C-clamp can also be used to press the stamp into leather. Sandwich the leather and stamp between press plates or wood blocks, then tighten evenly for a few seconds. For larger stamps, make sure each area of the design has been clamped so the full impression comes through clearly.